The motorized background lifter is designed for raising / lowering of backgrounds using a wired or wireless remote control (included). Changing the background not take seconds.   The elevator consists of a drive part with electric motors and a wired remote control, a mate lift and six shafts 3.15m long. The drive and mate housings are made of steel. Both cases have mounting holes. It is possible to install the lift both on the wall and on the ceiling. Seats for shafts are equipped with bearings and screw clamps. Backgrounds up to 3 m wide are wound on the shafts of the lift.   The lift is powered by AC power. Power cable length about 270 cm.   On the drive part there is a control unit with LED indication of the lift operation.   Remote controls Wired remote control is equipped with 6 buttons for each shaft. In addition, it has a power switch for the entire hoist as a whole. The cable length of the wired remote is about 210 cm.   Wireless radio remote equipped with an antenna to increase the range, buttons for raising / lowering backgrounds. The remote works from two 12V type 23A batteries. The effective range of up to 50 m. 6 shafts are provided in the lift kit. The shaft is an aluminum pipe with a diameter of 47 mm. One end of the shaft (without a hole for the retainer) is freely inserted into the hole in the mating part of the elevator. The second end (with a hole for the retainer) is inserted into the coupling of the drive part and secured with a bolt and nut from turning.